Reaper V3Ti Conversion Kit, Titanium 1.8mm MTL by EVL Vapors

The Titanium 1.8mm Conversion Kit allows for a quick and simple conversion of the Reaper V3Ti from the DL 2.7mm max airflow down to a less restricted 1.8mm for a restricted direct lung experience.

Made of Titanium.

Included in Kit

• 1.8mm air outlet deck with positive post fitted
• Airflow ring, offering six airflow options: 0.8mm, 1.0mm, 1.2mm, 1.4mm, 1.6mm, and 1.8mm

All EVL Vapors Reaper V3 products come securely packed in a metal tin and packed with Muji cotton for your wicking pleasure! Practical on two ends!

Installation Instructions:

1. Undo positive screw on the base of the atomizer.
2. Pull the fitted deck straight up and out.
3. Ensure small o-ring is located under the PEEK insulator disk.
4. Push the new deck into position.
5. Gently screw the positive screw on the base of the atomizer up.
6. Check the newly fitted deck does not wobble up or down or from side to side. If it does, press it down a little more and gently tighten the screw on the base again.
7. Swap out airflow ring.
8. Enjoy.

NOTE: It is highly recommend that you fully clean out this product before the first time you use it. While the factory does a decent job at removing dust, shavings, machining lubricants and greases, there is still the potential for trace elements to remain, and it is best recommended that you do an additional cleaning to meet your standard of cleanliness.

Vapes by Enushi is not responsible for misuse of product, or dangerously low coil builds. Vapes by Enushi is not liable for the use of improper batteries for your builds.