Reaper V3 MTL Restricted Dedicated Airflow Deck by EVL Vapors

The Reaper V3 MTL Restricted Airflow Deck allows for dedicated air flow outlets for a truly refined mouth-to-lung vaping experience.

Want the tightest possible vape from the V3? Look no further...

These dedicated airflow decks allow the under-coil airflow of the Reaper V3 to be locked to the following outlet sizes:

• 1.0mm
• 1.2mm

These decks are a direct replacement for the 1.8mm MTL or 2.7mm decks and allows the user to heavily restrict the airflow without the need to alter the airflow control ring, meaning you can now enjoy a super tight vape in combination with the tapered 22<24mm Hexairgon airflow ring!

Made from high quality 316 stainless steel and compatible with all versions of the Reaper V3.

Please be aware that this product listing is just for the deck. If you would like the MTL air flow ring, please purchase the >> MTL Conversion Kit << instead.

Installation Instructions:

1. Undo positive screw on the base of the atomizer.
2. Pull the fitted deck straight up and out.
3. Ensure small o-ring is located under the PEEK insulator disk.
4. Push the new MTL deck into position.
5. Gently screw the positive screw on the base of the atomizer up.
6. Check the newly fitted deck does not wobble up or down or from side to side. If it does, press it down a little more and gently tighten the screw on the base again.
7. Swap out airflow ring.
8. Enjoy.

NOTE: It is highly recommend that you fully clean out this product before the first time you use it. While the factory does a decent job at removing dust, shavings, machining lubricants and greases, there is still the potential for trace elements to remain, and it is best recommended that you do an additional cleaning to meet your standard of cleanliness.

Vapes by Enushi is not responsible for misuse of product, or dangerously low coil builds. Vapes by Enushi is not liable for the use of improper batteries for your builds.