Lab T16 (16mm) Extension Tube by Atmizoo of Atmizone

The T16 Extension Tube is a 16mm extension for all versions of the >> Lab << mechanical mod by Atmizoo.

This LA-T16 extension is only recommended for use in the following scenarios:

1. Powering the >> Lab 35 << with >> 18490 or 18500 << batteries.
2. Powering the Lab 50 with >> 18650 << batteries.
3. Using the Evolv Kick with any version of the Lab mod.

IMPORTANT:

The T16 extension has an internal diameter of 18.40mm, thus limiting the battery diameter to 18.30mm maximum, which means that some (usually low quality) batteries with thick insulation may not be able to pass through it.

It is preferred to use the T16 as a "new bottom cap" for your device. Keep the battery cap mounted on the T16 at all times, and unscrew the T16 from the device for battery installation/removal. Insert your battery inside the device, and screw the T16 back on, while keeping the battery cap attached to the T16 at all times. Make sure you back out the battery cap a bit before you remove/attach the T16 so that you may completely screw down the T16 to the Lab body. Make any necessary micro-adjustments with the bottom battery cap to ensure that the battery is held tight enough in place.

Warranty and Support

The Lab comes with a fair and generous >> warranty <<, which covers all manufacturing defects.

DISCLAIMER: Mechanical mods are for experienced vapers with access to meters and a working knowledge of Ohms Law, Watts Law, battery safety, and how general electricity works. Please ensure care is taken as to not cause damage nor harm to the atomizer, your battery, the vaping device, yourself, others, or personal property.

Vapes by Enushi is not responsible for misuse of product, or dangerously low coil builds. Vapes by Enushi is not liable for the use of improper batteries for your builds.