Description

Black DLC 3mL XS PSU Tank Conversion Kit for the GT IV (GT4) by Taifun

Replacement tank arrangement for the Taifun GT4 DLC RTA, allowing for a shorter height and lighter weight through the use of PSU - Polysulfone.

This is a BLACK DLC coated version of the standard silver >> GT IV 3mL XS PSU Tank Conversion Kit <<.

TIP: If the liquid control (LC) ring is difficult to move after installing this kit, replace the original o-ring on the LC ring with the included NBR50 17x1mm o-ring.

What is DLC?

DLC stands for Diamond-Like Carbon, a unique coating process that displays some properties similar to diamond, such as the hardness and medically inert, while bonding extremely well to materials like stainless steel. This means a high durability that does not scratch, chip, nor wear off like other coatings would, on stainless steel. Applied in a process somewhat similar to PVD (Physical Vapor Deposition), DLC is an even more resistant (but more expensive) finishing process. These are the only two methods known to reliably, and durably blacken stainless steel.

All externally visible surfaces of the DLC components are fully coated stainless steel. Due to manufacturing reasons, it is possible that some of the inner surfaces (hidden when assembled) may not be completely or not coated at all. Further, a rainbow effect can also occur. These deviations can also be different for identical components, but do not represent any defect of the part.

Benefits of PSU:

Very high strength and rigidity compared to other plastics.
High heat resistance (-50 to 170° Celsius).
Excellent chemical resistance, greater than Ultem to resist cracking from most liquids.
Physiologically inert.

Note: Photos shown attached to complete tank are for demonstration purposes only. Complete atomizer is not included in this sale. This sales listing is ONLY for the short 3mL tank conversion kit.

NOTE: It is highly recommend that you fully clean out this product before the first time you use it. While the factory does a decent job at removing dust, shavings, machining lubricants and greases, there is still the potential for trace elements to remain, and it is best recommended that you do an additional cleaning to meet your standard of cleanliness.