Reaper V3 Conversion Kit, 2.7mm DL by EVL Vapors

The 2.7mm Conversion Kit allows for a quick and simple conversion of the Reaper V3 from the MTL 1.8mm max airflow up to a less restricted 2.7mm for a restricted direct lung experience.

Included in Kit

• 2.7mm air outlet deck with positive post fitted
• Airflow ring, offering six airflow options: 1.0mm, 1.2mm, 1.5mm, 2.0mm, 2.5mm, and 2.7mm

All EVL Vapors Reaper V3 products come securely packed in a metal tin and packed with Muji cotton for your wicking pleasure! Practical on two ends!

Installation Instructions:

1. Undo positive screw on the base of the atomizer.
2. Pull the fitted deck straight up and out.
3. Ensure small o-ring is located under the PEEK insulator disk.
4. Push the new deck into position.
5. Gently screw the positive screw on the base of the atomizer up.
6. Check the newly fitted deck does not wobble up or down or from side to side. If it does, press it down a little more and gently tighten the screw on the base again.
7. Swap out airflow ring.
8. Enjoy.

NOTE: It is highly recommend that you fully clean out this product before the first time you use it. While the factory does a decent job at removing dust, shavings, machining lubricants and greases, there is still the potential for trace elements to remain, and it is best recommended that you do an additional cleaning to meet your standard of cleanliness.

DISCLAIMER: Rebuildable atomizers are for experienced vapers with access to meters and a working knowledge of Ohms Law, Watts Law, battery safety, and how general electricity works. Please ensure care is taken as to not cause damage nor harm to the atomizer, your battery, the vaping device, yourself, others, or personal property.

Vapes by Enushi is not responsible for misuse of product, or dangerously low coil builds. Vapes by Enushi is not liable for the use of improper batteries for your builds.