Lab HP Edition Internal Switch Assembly by Atmizoo of Atmizone

The HP Edition Internal Switch Assembly is a High Performance internal switch assembly for all versions of the >> Lab << mod by Atmizoo, and is a lower maintenance, heat-resistant version suitable for switching higher power.

Comes with button for your >> Lab <<. Please choose the version to match accordingly with your >> Lab << mod's finish.

The HP Switch Assembly is manufactured using PEEK insulators and is suitable for use up to 250°C. Compared to the standard version made of Delrin, this durable heat-resistant switch is suitable for switching higher power with lower maintenance requirements.

The HP switch assembly includes the following components:

• Liquid-sealed internal switch housing (HP Edition) with a 14x1.0mm o-ring.
• Moving Axle (HP Edition) with a 4mm spring.
• Silver-plated Contact Rod.
• 2mm Ball-Bearing and 2mm diameter Spring.
• Hexagonal Battery-side Contact, silver-plated.
• Hexagonal, liquid-sealed Atomizer-side Contact, silver-plated with 10x1.5mm o-ring.
• Adjustable-height 304 SS >>Pole Screw<<.
• Liquid-sealed Pole Insulation Cap with 7x1.0mm o-ring.
• Lab Button Washer
• Lab button in either SS-M SS Matte (machine brushed) finish or SS-IM SS Iced Matte (media blasted) finish.

The Delrin Button Washer is optionally mounted around the button and can be safely removed if you prefer the look of the device without it.

Important Notice #1

Due to its high temperature tolerance, the HP switch assembly will keep operating even under extreme conditions. Therefore, it is only recommended for use with the >> Lab << in Fused Mode, or with secondary protection circuitry installed (such as an Evolv Kick2). Use common sense: Never leave your device unlocked in bags or pockets when using the HP switch assembly. When carrying a device with an HP switch assembly installed, it is recommended to slightly unscrew the bottom cap in order to disconnect the battery completely.

Important Notice #2

PEEK shows different material tolerances from Acetal / Delrin (normal switch version). This means that you also need a button with slightly different specs, so that it can fit properly when pressed on the PEEK axle.

This is why we request the material and the finish of the button on your device, as your button will not fit this HP Edition assembly if you are upgrading from a normal version of the >> Lab <<. The extra button will come to you at no extra cost.