SnailTank by Atmizoo

The SnailTank by Atmizoo is a replacement alternative tank solution for the Boro Tank by Billet Box Vapor, fits most RBA's and Bridges, and allows users to change the look of their setup while also adding additional features and functions!

Made of chemically resistant PCTG, it is available in Clear, Smoked Black, Electric Blue, Fuchsia, and Ultem Yellow.

The SnailTank consists of two main parts: a tank section and an adapter (base), plus some extra custom silicon gaskets. The tank section is cross-compatible with the VapeSnail tank kit, while the adapter (base) essentially takes the place of the VapeSnail deck to create a hosting base for your Boro RBA or bridge. Tank section and adapter together create a form with outer shape which is almost identical with the classic Boro tank.

The SnailTank can be refilled through a large refill hole on the top-left corner, and is sealed with a custom silicon gasket.

An important feature added, is the ability to access your RBA deck or factory-made coil, even with liquid in the tank, at any time - very much like what was introduced with the VapeSnail. It is even possible to access the deck when the tank is completely full with liquid when used with the VapeShell or other RBA's with a similar connection between the evaporation chamber and deck (non-threaded, not extra tight o-ring intervention between the two parts). Last but not least, it features a Chimney Gasket, which is added on the top side of the tank section to adjust the hole to the diameter of Boro standard bridge chimneys and offer some extra advantages. Among other things, it seals with the AIO 510 nut, even if you remove the sealing oring that most nuts or hybrid drip tips have.

Placing an additional silicone gasket at the top allows the elimination of two issues:

1. The usual pain when the chimney of the bridge is automatically lifted up while unscrewing the nut / hybrid drip tip.
2. The poor seal that most hybrid drip tips present, either because of normal tear and wear, or due to bad choice of o-rings (or even no presence of orings at all).

It is advised to remove the hybrid drip tip oring or the 510 nut oring to enjoy the best out of the SnailTank.

Due to its design, the SnailTank is compatible with most bridges, RBAs and condensation plugs that are designed for the Boro tank (eg the Velvet Vape Boropad works perfect).

Cross-compatibility of the tank section with the VapeSnail was a primary goal. This, together with its pyramid-like shape due to the unavoidable draft angle of the molding process, made the tank a bit less spacey. For this reason, very large RBAs (indicatively Haku Xeta, SVT Crossbow, Hellfire Exocet v2) are expected to fit with zero tolerance inside the SnailTank. This won’t affect functionality but might leave a friction mark on the inner walls of the tank after insertion / removal of these large RBAs. The inner wall's minimum width of the tank section is 13.70mm, so any RBA with smaller width than that will fit fine.

The SnailTank is made of a special medical grade co-polymer plastic called PCTG. It’s the same plastic that is used for approved baby bottles and medical appliances, FDA approved, totally safe, as it is BPA free and 100% resistant against cracker liquids (citrus, menthol etc.) unlike other plastics (PCTE, polycarbonate, plexi glass etc.).

Each SnailTank comes with two sets of silicon gaskets / o-rings. A clear one (preinstalled on Clear, Electric Blue, Ultem Yellow and Fuchsia, spare with Smoked Black) and a black one (preinstalled on Smoked Black, spare with Clear, Electric Blue, Ultem Yellow and Fuchsia).

These are the parts of the SnailTank (PCTG plastic parts and food-grade silicon parts):