Taifun GT IV (GT4) 2018 2mL Pure Glass Edition RTA

This variant of the >> Taifun GT IV RTA << comes pre-configured with the >> GT IV 2mL Pure Glass Tank Kit << for users wanting a more compact setup, or for regions where the importation of tanks are restricted to less than 2mL of liquid capacity.

Note: The Top Cap and Chimney design of this variant is different from the standard/international full-sized variant of the Taifun GT IV, and the top cap design is NOT interchangeable between the two versions, due to the way the glass tank attaches to the chimney.

The Taifun GT4 is the fourth iteration in the Taifun GT series, bringing a number of enhancements unlike any Taifun GT RTA before! Now with a large build deck and significantly larger air flow, allowing for the installation of large complex wire builds, and capable of higher wattage vaping.

Juice flow control is integrated into the base itself. Turning the liquid flow control ring against the base will adjust the juice flow aperture, and eliminates the need for proprietary keyed drip tips.

Note: Screwing the tank section too tight down on to the tank base will result in locking the liquid flow control ring in place. Be sure to only screw on the tank section while the liquid flow control ring is fully closed, and do not over tighten the tank on to the base. Leaving a bit of room will allow you to maintain the ability to rotate the liquid flow control ring.

Air flow is easily adjusted by turning the air flow control ring at the base of the deck.

The build deck features SIX posts, allowing for a number of creative builds, from single to dual, to triple coil builds, horizontal coils, vertical coils, and more! Get creative!

Six air outlet ports direct air flow to strike the coil from underneath the coil at an angle from both sides of the coil, fully enveloping the coil in air, resulting in very flavourful vapour production.

Top cap easily removes for top filling. Be sure to fully close the juice flow control before filling, to prevent flooding the deck.

Taifun GT IV 2023 Specifications:

• Diameter: 25mm at the base, 25.55mm at the widest point (Corners of flat edges).
• Height: 40mm (without drip tip and connection screw)
• Liquid capacity: 2 mL
• Food safe materials (1.4301 stainless steel and PEEK)
• New air duct system via the poles in the chamber with adjustable AFC from the outside. Individual flow to the coil via one of the two, or both poles are possible.
• For restricted direct lung to direct lung, or for a wider open draw direct lung via installation of >> Open Draw PlusPol << or >> Titan Open Draw PlusPol <<
• Multiple wire mounts (6 points of connection) to enable easy and versatile installation of coils. Optimized for single coil builds, but dual coil builds are possible
• Intuitive liquid control system, adjusted externally
• Top fill
• Interchangeable tank options.

Note: The Taifun GT IV is not designed for use on pure hybrid mech mods. The 510 center pin is NOT adjustable, and should not be released for this purpose.

Taifun GT IV 2023 Package Contents

• Taifun GT IV 2018 2mL Pure Glass atomizer
• Spare parts bag
• 1.3mm hex key
• Instruction manual

NOTE: It is highly recommend that you fully clean out this product before the first time you use it. While the factory does a decent job at removing dust, shavings, machining lubricants and greases, there is still the potential for trace elements to remain, and it is best recommended that you do an additional cleaning to meet your standard of cleanliness.

DISCLAIMER: Rebuildable atomizers are for experienced vapers with access to meters and a working knowledge of Ohms Law, Watts Law, battery safety, and how general electricity works. Please ensure care is taken as to not cause damage nor harm to the atomizer, your battery, the vaping device, yourself, others, or personal property.

Vapes by Enushi is not responsible for misuse of product, or dangerously low coil builds. Vapes by Enushi is not liable for the use of improper batteries for your builds.