Armor 1.0 RDA #5AniEdition by Armor Mods

This 5th Anniversary Edition "#5AniEdition" of the Armor 1.0 RDA by Armor Mods is the embodiment of 5 years of experience in this industry, incorporating technological and material advancements in the vaping industry over time, making this the ultimate Armor 1.0 RDA release to date.

CANADIAN COMPLIANCE NOTE: This product is NOT certified as a CRC product in Canada, and as such, can not be sold within Canada. This product is for export only. Any online orders within Canada for this product will be cancelled and refunded.

No sales to Asia. For all sales to Asia, please contact ARMOR Mods or Oriental Vape directly.

The Armor 1.0 RDA is highly regarded as one of the best rebuildable squonking/dripping atomizers of all time, thanks in big part to its aesthetic, build flexibility for single or dual coils, variety of accessories, and most importantly; the performance.

Limited to only 500 pieces, this Fifth Anniversary Edition release of the Armor 1.0 has been upgraded in numerous areas, making this Armor 1.0 release the best one to date. The following design points are featured in this special limited release:

• Original Armor 1.0 Two-Post coil build design has been maintained, along with ability to install dual or single coil builds.
• Classic PEEK Single Coil Reducer (SCR) is included to cut the deck's negative space in half when operating in single coil mode.
• Original small evaporation chamber has been maintained for maximum flavour production.
• Original interior rounding of the evaporation chamber cap has been maintained, for smoother (less turbulent) air flow for more direct flavour production.
• Coil attachment posts are now reinforced to resist bending and flexing when tightening the 510 center screw or the coil leg screws.
• Top cap airflow is now wider. Full width is same as the original "Armor Cloud Cap". Can be infinitely adjustable closed to a smaller sizes by rotating the inner cap against the outer cap.
• Air inlet ports now have a radius applied to the ends to eliminate turbulence whistling.
• Proprietary sized Armor RDA drip tip now comes standard as natural PEEK for higher heat reflectivity and resistance to prevent deformation and damage while minimizing heat transfer to the user's lips for very hot dual coil builds.
• SS top cap comes standard in this 5AniEdition as a black DLC coated cap, for maximum hardness and durability, with a rich satin black finish.

Armor 1.0 RDA #5AniEdition Scope of Delivery

• 1x Armor 1.0 #5AniEdition RDA
• 1x 510 display stand/case
• 1x Black DLC Cloud Cap Set (installed)
• 1x Natural PEEK Drip Tip (installed)
• 1x Spare O-Rings Set
• 1x Bottom Feed Pin (installed)
• 1x Solid Pin for standard dripping
• 2x Spare coil post screws
• 1x PEEK Single Coil Reducer (SCR) (installed)

WARNING: It is highly recommend that you fully clean out this product before the first time you use it. While the factory does a decent job at removing dust, shavings, machining lubricants and greases, there is still the potential for trace elements to remain, and it is best recommended that you do an additional cleaning to meet your standard of cleanliness.

DISCLAIMER: Rebuildable atomizers are for experienced vapers with access to meters and a working knowledge of Ohms Law, Watts Law, battery safety, and how general electricity works. Please ensure care is taken as to not cause damage nor harm to the atomizer, your battery, the vaping device, yourself, others, or personal property.

Vapes by Enushi is not responsible for misuse of product, or dangerously low coil builds. Vapes by Enushi is not liable for the use of improper batteries for your builds.